LAND ROVER DISCOVERY 1 AND RANGE ROVER CLASSIC.
INNER SILL BODY MOUNT REPAIRS.
A COMPLETE FIX FOR THE CORROSION IN THIS SECTION OF THE BODY SHELL
Our sill repairs are usually sufficient to repair this area of the vehicle but for
older models or vehicles that have suffered badly with corrosion around the body
mounts, these kits enable a solid repair. removing the need to replace the complete
a hugely time consuming job.
Our ''EASY ON'' body mounts and our unique inner sill repair plates will allow you to replace the body mount and secure it to the inner sill.
ARE THEY ANY GOOD ?
CLICK ON OUR FEED BACK LINK
HOW DO I FIT THEM ?
Watch the video (COMING SOON)
ALL WELDING WORK UNDERTAKEN.
TRY OUR SPEEDY FITTING SERVICE WE ARE
''EASY ON'' YOUR POCKET AS WELL
NOW ALSO AVAILABLE
All the rust killer, paint, sealant, under seal and wax required
to fit your ''EASY ON'' repair panels.
Enough materials to refinish a pair of sills or a combo of other repair panels. All from one place, all great value, all picked to be the best products for the job, delivered to your door.
Ensure your repair lasts
use FERTAN on all rusty areas before you weld in our replacement panels,
to ensure all rust under and around the repair is killed permanently.
Seal around your repair with POLYFLEX over paintable, moisture curing, polyurathane sealant.
Over paint sealant repair and surrounding area with BESAVAL no primer, gloss black paint.
Spray or brush TETRA SCHUTZ under seal to underbody areas.
Over spray all when dry and spray into cavities with
Use in conjunction with ‘’EASY ON’’ sill repairs, A and B post boots, inner and outer wheel arch panels.
Remove the old mount and trim away badly corroded areas then bolt the new mount into place
Slide the inner sill repair plate into position
Clamp up then weld into place.
REAR OF SILL
FRONT OF SILL
Super fast to fit with minimal strip down.
These sections fit exactly were they are needed.
Will fit all Range Rover Classic and all Disco 1s,.
Body mount and back plate are made from 2mm steel plate.
Sill finisher, floor support and rear wheel arch plate are of 1.6mm zintec coated steel.
BULKHEAD BODY MOUNTS INCLUDING INNER WING SUPPORT
Sold as full kits with mounting bushes and inner wing supports or as individual mounts.
Body mount and inner wing support are 1.5 mm zintec coated steel with 3mm reinforcing plates